Also agree, great kit, build quality of all components was terrific! Tips & Details on install...On my Suburban, I also had to use a number of shim washers under bracket to elevate it properly to clear hood when opening, no biggie...just make sure you use stainless steel for all shim washer & bolt & lock-washer components, and don't be afraid to crank the bolt down hard to properly secure it. Where side of bracket inevitably touches fender area, I also wrapped it in a few turns of elec tape & even added some adhesive backed drawer 'felt' liner to reduce potential grinding of metal on metal. I fed the small end of antenna cable thru nipple on big rubber grommet on firewall (its conveniently right nearby, don't forget to add a 'drip-loop'!) If you go this route, be prepared to loosen the fuseblock underneath dash above brake pedal, to improve access to snake the antenna thru. Its a good install but hard to do and I even paid a price for it - I damaged the plug end ruining the isolation (more below.) Cannot stress this enough - BEFORE attaching antenna to radio, PERFORM a CONTINUITY test to verify both grounding of bracket and for damage to antenna cable & plug!!! In routing antenna thru firewall, I damaged the plug end such that it shorted out the entire assembly, no isolation, not good. I replaced the original plug with a new PL-259 plug....confirmed everything was grounded & isolated, performed my SWR test (followed RCR's instructions precisely) and it all now works perfectly (SWR = 1.2!) Highly recommend Right Channel Radios, great guys, great service - wished everyone treated their customers like they do. (PS - My radio is a Midland 75-822, love it.)