Free shipping $99+ (excludes antennas)
TECHNICAL & INSTALLATION RESOURCES | 100,000+ SATISFIED CUSTOMERS TECHNICAL & INSTALLATION RESOURCES
100,000+ SATISFIED CUSTOMERS

Truck Stake Hole CB Antenna Kit Best Seller

$44.95

  • Installs securely inside the stake holes that run along the bed rails of pickup trucks
  • CheckFree Shipping over $99*
  • CheckIncludes Installation Resources
  • CheckHassle-Free Returns

There’s a lot of reasons you love your truck. You can tackle rough terrain. You can tow stuff. You can sleep in your bed under the stars. And let’s not forget - women dig them. It’s this love affair that inspired the stake hole kit. The mount has a plate connected by four bolts, allowing the stainless steel mount to easily and securely attach to the inside of the stake hole for a no-drill installation. Kit includes 18' of quality Firestik coax cable with a low-profile, weather-resistant ring end. Perfect for single or dual antenna setups, this mount creates a sturdy mounting platform that can support antennas up to 5' and is 100% pickup driver approved.

Model / SKU:Firestik MK-294R
Recommended for:
Pickup trucks. This mount attaches to the inside of stake holes along the bed rails of pickup trucks. If installing on the stake holes directly behind the cab, we recommend using at least a 4' antenna. Shorter antennas may experience SWR and performance issues due to being so close to the cab without ample room above the roof line. Can support antennas up to 5' tall.
Compatible with:All CB radios, and all fiberglass and center-load antennas that use a standard 3/8" x 24 threaded base.
Installation Notes:Important Note: The PL-259 connector (radio screw-on end) is supplied in this kit but is NOT installed on the coax cable. This allows the cable to be routed into the vehicle through a smaller (0.375") hole. After the connector is placed on the coax, the center must be soldered to the PL connector.

To install this mount, you'll need to loosen the plate connected to the stake-hole mount. The plate will go on the inside of the stake hole. Once you've slid the plate inside the hole, tighten the four bolts and the plate around the bottom lip of the stake hole. Be sure that either the mount or mounting plate have direct metal-to-metal contact with the frame in order to achieve a solid ground.
Mount Location:Flat Surface (Roof, Bumper), Other
Stud Type:Lug (Ring and Terminal)
Material:Stainless Steel
Warranty:Two years
Product Includes:Firestik Stake Hole Mount and Hardware
18' of Firestik FireRing CB coax cable

Firestik CB Antenna Mount: The square holes in the bed rails of full-sized pickup trucks are the prefect location for a no-drill antenna mount. The flat upper bracket is 6" (152mm) long and extends out over the bed rail, so you can mount your antenna without losing the ability to mount a camper shell. Includes stud mount, stainless steel brackets and hardware, and a gasket to protect the vehicle finish.

IMPORTANT: When mounted in either of the stake-hole pockets directly behind the vehicle cab, antennas under 4' will experience substantial reflection from the metallic corners of the cab (between the side and rear glass). As a result, shorter antennas will likely be difficult -- if not impossible -- to tune to a satisfactory SWR. Subsequently, we recommend antennas longer than 4' with this mount.

Reviews