This cable kit for dual antennas makes use of Firestik's popular and respected FireRing cable connectors, high-quality cable and mini-UHF connectors for easy cable routing through tight places.
In order to make the co-phase harnesses as user friendly as possible, we needed to make them easy to route. Since it would require a 1" hole to pass the FireRing through, we had to come up with a better idea, which lead to mini-UHF connectors. Most co-phase harnesses are routed from the radio to the mounts. If you want the convenience of PL-259 connectors, you either had to drill 3/4" holes or have the knowledge and tools to install PL-259 connectors once the cable was routed. This package from Firestik changes all that.
With this assembly, you run each leg of the co-phase harness from each mount to the radio. Since the radio end of these cables are terminated with female mini-UHF connectors, they will pass through a 7/16" (11mm) hole. After both leads are at the radio, you simply attach the "Y" connector to the ends and attach it to the radio. No coax to process, no soldering joints to complete and no tools needed. And best of all, you get all of the benefits of our exclusive FireRing connectors.
FireRing terminations require FireRing K-4R stud mounts that include 1.25" long bolts.
Mounts that have Standard K-4 stud mounts can be adapted for use with the FireRing termination by replacing the 1" bolt with a 1.25" bolt and elimination of the ring terminal, one flat washer and one nylon washer.
- Requires compatible FireRing Antenna Studs
- Stranded center conductor to maximize flexibility and prevent untimely breakage.
- Shielding coverage that averages 95% to protect against RF leaks and interferrence.
- Polyvinyl center insulation for ruggedness and longivity.
- Performance that exceeds mil-spec requirements for 50 ohm RG-58A/U coax.
Model Number: Firestik MU-9R18
Visit manufacturer's website.
